Rigol MSO1000Z series - Page 142

RIGOL Chapter 6 MATH and Measurement
6-32 MSO1000Z/DS1000Z User’s Guide
Its unit is the same as that of the current signal source.
 BX-AX: the horizontal difference between cursors A and B.
 BY-AY: the vertical difference between cursors A and B.
 |dX|: when the horizontal unit selects “s”, |dx| represents the time difference
between cursors A and B; when the horizontal unit selects “Hz”, |dx| represents
the frequency difference between cursors A and B;
 1/|dX|: the frequency difference between cursors A and B.
When the measurement source is set to LA, the measurement results will be
displayed at the upper-left corner of the screen in the following form.
 AX: the X value at cursor A. X value takes the trigger position as reference.
 D15-D0: display the logic level values at cursor A (D15-D0 from left to right) in
hexadecimal forms. If the digital channel is currently turned off, it will be
denoted by “*”.
 BX: the X value at cursor B. X value takes the trigger position as reference.
 D15-D0: display the logic level values at cursor B (D15-D0 from left to right) in
hexadecimal forms. If the digital channel is currently turned off, it will be
denoted by “*”.
If needed, please refer to the following steps to modify the parameters of manual
cursor measurement.
1. Select Cursor Type
Press Select to select “ ” or “ ”.

: the X cursors are a pair of vertical solid (cursor A)/dotted (cursor B)
lines and are usually used to measure time parameters.

: the Y cursors are a pair of horizontal solid (cursor A)/dotted
(cursor B) lines and are usually used to measure voltage parameters.
Note: When the current measurement source is LA, the cursor type is
“ ” and cannot be set.
2. Select Measurement Source
Press Source to select the waveform of the analog channels (CH1-CH4), math
operation results (MATH) or LA waveform for measurement.
Note: Only channel currently enabled can be selected.
3. Adjust Cursor Position
 Adjust cursorA: press CursorA and use to adjust the position of
cursorA. The measurement result will change accordingly during the