Rigol MSO5000-E Series

Chapter 1 Disassembly and Assembly RIGOL
MSO5000-E Service Guide 1-13
Disassemble the Keypad Board
Figure 1-10 Disassemble the Keypad Board
Part Description:
① 6 screws (M3x8 torx pan head combination screw, used for fastening the keypad board)
Disassembly Steps:
1. Remove the rubber keypad.
2. Use the T10 screwdriver to remove 6 screws (①) that secure the keypad board.
3. Take off the keypad board gently.
Tip
 When assembling the keypad board, align the pin headers at the back of the keypad board
with the slots on the main board.
 After the keyboard is properly installed, ensure that all the rubber keypads on the front panel
work normally.
Keypad Board
①×6
Rubber Keypad