Rinnai HE Series User Manual

KBD Series Manual
How to Set the Temperature
While any hot water is being provided,
the temperature seng can only be
adjusted between 98° F and 110° F.
NOTICE
Check local codes for the maximum water
temperature seng allowed when used
in nursing homes, schools, day care
centers, and all other public applicaons.
NOTICE
If a newly installed unit with a controller
has not been powered for at least 6 hours
then the temperature will return to the
default seng of 104° F (40° C) if power is
interrupted.
NOTICE
There may be a variaon between the
temperature displayed on the
temperature controller and the
temperature at the tap due to weather
condions or the length of pipe to the
water heater.
NOTICE
1. If the water heater is off, press
the Po
wer buon to turn on
.
2.
If the Priority light is off, th
en
press the
“Priority buon” on the
temperature controller. Th
e
oran
ge Priority light will glow
indicang that this controll
er is
co
ntrolling the temperature
and
that the
water heater is ready to
supply hot water. (The priority
can only be changed while no ho
t
wat
er is running.)
3.
Press the up or down buons to
obtain the desired temperature
seng.
All hot water sources are able to
provide water at this temp
erature
seng unl it is
changed again
at
this o
r another temperature
controller.
DANGER
Water
temperatures over 125° F (52° C) can cause severe burns or scalding
resulng in death.
Hot water can cause first degree burns with exposure for as lile as:
3 seconds at 140° F (60° C)
20 seconds at 130° F (54° C)
8 minutes at 120° F (49° C)
Children, disabled, or elderly are at highest risk of being scalded.
Feel water before bathing or showering.
This water heater requires a minimum flow rate to operate. This rate can be found on the specificaon page in
this manual. In some cases when you are not geng hot water or if the water alternates between hot and cold,
it is due to the water flow being below or close to the minimum flow rate. Increasing the flow rate should
resolve these problems in these cases.
If you are experiencing issues with higher temperature sengs, then reduce the temperature seng. Selecng a
temperature closer to that which is actually used at the faucet will increase the amount of hot water being
delivered to the faucet, due to less cold water mixing at the fixture.

Rinnai HE Series Specifications

General

Brand	Rinnai
Model	HE Series
Category	Water Heater
Language	English