User Functions and Settings
LightSYS User Manual Page 40
Switch AUX: Interrupts the power supplied to the system's
smoke detector(s) for a predetermined interval, thus resetting and
"readying" them for subsequent alarms
Overload restore: Use this option to restore overloading of the
system’s switched power supply. If the overload condition is still
present, disconnect all loads from AUX.
Destination: Used to define (up-to-16) Follow Me destinations
according to its type: Voice message, SMS or E-mail. For more
information refer to page 31.
Label: Identifying labels for the Follow Me destination. Enter the
labels according to the instruction defined for user label on page
28
If Follow Me destination(s) were chosen, their operation can be
terminated. Use this function when an alarm has been tripped
and there is no need to utilize the Follow Me feature.
Used to test Follow Me reporting.
Should be used when the system has detected a problem, which
is evidenced by the rapid flashing of the power icon, as
described on page 9.
Displays the five most recent alarm conditions stored by the
system.
To Next Page
Loading...
