Riso SF5 Series - Page 51

Chapter 2 Working with the Printer Driver
49
Chapter 2 Working with the Printer Driver
49
7
Fittoprintablearea
If the original page does not have enough margin for printing, it is normally printed as it is without page size reduction.
If the original page has a smaller margin, the part that exceeds the effective print range is not printed out.
In such case, if you place a checkmark here, the whole page is printed out by adding a margin (changing the
reduction rate) and preventing the edge of the paper from being removed.
B
This option is not available when [Margin-plus] is selected.
8
180-degreerotation
You can rotate print images by 180 degrees by activating this option.
B
Youcanset180-degreerotationfromyourprinter.Ifyousetitbothfromyourprinterdriverandprinter,theprint
imagesdonotrotateby180degrees.
9
Margin-plus
If you select this check box, printing will be done in a 95% scaling.
B
If [Fit to printable area] is not selected, this option is not available.
B
If [Print position adjustment] is selected, this option is not available.
0
Printpositionadjustment
When you print the original on a sheet of paper that is larger than the original, this option adjusts the printed position
without changing the printed original size.
Placing a checkmark and clicking [Details] opens the [Print position adjustment] dialog box. Set the position and the
unit.
The settable range varies depending on the original size and the print paper size.
Reset : Clicking [Reset] returns to the original position.
B
If [Margin-plus] is selected, this option is not available.
B
If you set [Imposition] to other than OFF, this option is not available.
B
You can select the unit of size from [mm] and [inch].