26
System reset
If your radio fails to operate correctly, or some digits on the display are
missing or incomplete carry out the following procedure.
1. Press the On/Off button to switch on your radio. The radio will beep
to conrm that it is now switched on.
2. Press the Tuner button to select either the DAB or FM mode.
3. Apply a long press on the Time/Set button (approx. 8 seconds) until
'Restarting...' shows on the display.
4. A full reset will be performed. The station list and presets will be
erased. Settings will be set to their default values. After a few seconds
a station scan search will be performed automatically. The radio will
then restart as when rst plugged in (see also page 6).
Electro-magnetic compatibility advice
In the event of a malfunction due to electrostatic discharge, mains power
supply transients or short interruptions, reset the product as above to
resume normal operation. If you are not able to perform the reset operation
as above, removal and reconnection of the power supply and batteries
may be required.
If the product is used in an environment with any ESD Immunity / Radiated
Immunity / Conducted Immunity disturbance, the product may malfunction.
It will automatically recover to normal when the ESD Immunity / Radiated
Immunity / Conducted Immunity disturbance is stopped.
Product markings
DC Voltage
Power input 7.5V / 2A
USB output 5V / 180mA
Recycling
This product bears the selective sorting symbol for
Waste Electrical and Electronic Equipment (WEEE).
This means that this product must be handled
pursuant to European directive 2012/19/EU in order
to be recycled or dismantled to minimize its impact on
the environment.
The user has the choice to give the product to a
competent recycling organization or to the retailer
when buying a new electrical or electronic equipment.
On/Off
Restarting...
Time Set
Repeat
& Intro
Tuner
DAB
FM
10
To Next Page
Loading...
