EasyManuals Logo

Robin EY45V User Manual

Robin EY45V
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
a) Intake manifold
b)
Insulator
Be careful of its mounting direction.
Intake Manifold Side Carburetor Side
Intake manifold side
Carburetor side
c) Carburetor
*Pay attention to the types
of
gaskets on
the front and back.
.Install the governor rod, rod spring, and
choke rod.
d)
Elbow and support (elbow)
Install the breather pipe between the crank-
case and elbow.
e) Air-cleaner case
Place the air-cleaner case on the elbow and
intake manifold, check that it
is
properly
positioned relative to them, and tighten it.
f) Cleaner element, cleaner cover
Fig.
33
2
1)
Governor lever and speed control
a)
Governor lever
Hook the governor rod and rod spring to the end
of
the governor lever, and install the lever
on
the
governor shaft.
b) Speed control, governor spring
Hook the choke rod
to
the choke lever. Install the governor spring
on
the governor lever and speed
control.
22)
Governor set
Pull the speed control lever
in
the high speed directim, fully open the carburetor throttle valve, turn
the governor shaft clockwise all the way, and tighten the governor lever bolt.
NOTE: The engine speed setting procedure
is
described in
a
separate section.
23)
Muffler
Replace the muffler gasket with a new one, and install the muffler and muffler bracket.
Muffler nuts:
M8
flange nuts (stainless steel)
Tightening torque:
180
-
220
kg-cm
After tightening the flange nuts, bend the tabs
of
the lock washers for the heat deflector to prevent the
nuts from turning loose.
-
28
-

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Robin EY45V and is the answer not in the manual?

Robin EY45V Specifications

General IconGeneral
BrandRobin
ModelEY45V
CategoryEngine
LanguageEnglish

Related product manuals