Robitronic Expert LD 80 - Warnings and Safety Notes; General Usage Precautions; Battery Type Specifications

NiMH/NiCd
LiIo
LiPo
Life
Pb
LiHv
-
27
-
Voltage level: 3.6V/cell
Max. charge voltage: 4.1V/cell
Allowable fast charge current: 1C or less
Min. Entladeschlussspg: 2.5V/cell or higher
Voltage level: 3.7V/cell
Max. charge voltage: 4.2V/cell
Allowable fast charge current: 1C or less
Min. discharge voltage cut off level: 3.0V/cell or higher
Voltage level: 3.8V/cell
Max. charge voltage: 4.35V/cell
Allowable fast charge current: 1C or less
Min. discharge voltage cut off level: 3.0V
Voltage level: 3.3V/cell
Max. charge voltage: 3.6V/cell
Allowable fast charge current: 4C or less (e.g. A123M1)
Min. discharge voltage cut off level: 2.0V/cell or higher
Voltage level: 2.0V/cell
Max. charge voltage: 2.46V/cell
Allowable fast charge current: 0.4C or less
Min. discharge voltage cut off level: 1.5V/cell or higher
Voltage level: 1.2V/cell
Allowable fast charge current: 1C~2C, depends on the
Performance of cell discharge voltage cut off level:
0.85V/cell (NiCd), 1.0V/cell (NiMH)
3. Warnings and safety notes
• Never leave the charger unsupervised when it is connected to its power
supply. If any malfunction is observed immediately terminate the process and
refer to the operation manual.
• Keep away the unit from dust, damp, rain, heat direct sunshine and vibration.
Do not drop it.
• The circuit of the unit is designed to be powered by a 10-18V DC only.
• This unit and the battery to charge or discharge should be set up on a
headresistant, non-inflammable and non-conductive surface. Never place them
on a car seat, carpet or similar. Keep all the inflammable volatile materials well
away from operating area.
• Be sure to understand the information of the battery to be charged or
discharged accurately. If the program is set up incorrectly the battery can
severely be damaged. Especially Lithium battery can cause a fire or an
explosion by over-charging.