EasyManuals Logo

Robomow MC300 Operating Manual

Robomow MC300
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
28
5.2.4 Main Zone Area
• Scroll to select an approximate area (EU- m² / US- ft²) of
the Main Zone, where the Base Station is installed.
If an additional zone (Sub-Zone or Separated Zone)
exists, do not include it in this area (it will be set
separately).
Note – It is necessary to complete the above settings (5.2.1 –
5.2.3) in order to operate the mower. Every press on the
STOP button will change the screen one step back in the
process.
5.2.5 Test Base Station
Position
• After setting the area, U001 (Test Base Station Position)
is displayed.
• Place Robomow inside the lawn, approximately 3 m (10
ft.) in front of the Base Station, facing the Perimeter Wire
and press OK to start the test.
• Robomow drives towards the Base Station:
If the mower does not start the test, then one of
the following messages will be displayed:
E3 (
No Wire Signal
)
Conrm that the Power
Box is connected to the power outlet and that
the Extension Cable is connected at both ends,
from the Power Box to the Base Station.
U029 (
Swap wires in plot connector
)
The
Perimeter Wire has been connected in the
opposite direction. Swap the wires at the plot
connector.
• Robomow will enter the Base Station, drive back, wait in
front of the Base Station, and display
U002
(
Peg Base).
If
U051
(Reposion Base Staon)
message is
displayed:
• Move the Base Station slightly to align it with
the Perimeter Wire.
• Check for any obstacles that may interfere
with the mower’s entrance to the Base
Station.
• WhileU002’ (Peg Base) is displayed, insert the remaining
Stakes of the Base Station to secure it to the ground and
press OK.

Other manuals for Robomow MC300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Robomow MC300 and is the answer not in the manual?

Robomow MC300 Specifications

General IconGeneral
TypeRobotic lawn mower
Cutting width280 mm
On/off switchYes
Cutting system-
Recommended lawn area300 m²
Maximum cutting height60 mm
Minimum cutting height15 mm
Grass collecting volume- L
Battery typeLiFePO4
Power sourceBattery
Battery voltage26 V
Battery technologyLithium
Weight and Dimensions IconWeight and Dimensions
Depth460 mm
Width630 mm
Height210 mm
Weight11100 g

Related product manuals