Robomow MC300 Operating Manual

16
4. Initial Setup
4.1 Preparaons
Recommendation before you start:
During setup, you will insert pegs into the ground. To complete
this task smoothly, we recommend not to do it while the grass
is high and to water it before starting.
4.1.1 Getting Ready
Make sure all parts needed for setup are within reach. Have
the Robomow box nearby, so all items are available.
In addition, you will need the following tools: A hammer, small
at screwdriver, Phillips screwdriver, Combination Pliers.
4.1.2 Installing the Power Box
Mount the metal bracket onto a vertical surface with the
provided screws. Make sure the narrow part with the holes
facing up as shown in the gure to the right.
• Place the Power Box above the metal bracket and slide
it into place along the vertical surface.
• Connect the Power Box to a regular power outlet (230V
/ 120V).
4.1.3 Charging the battery before the rst operation
You can charge the Robomow battery while running the setup of the Perimeter Wire. This will ensure that Robomow
will be ready for operation when the setup is completed.
• The power of the mower is switched off when shipped
from the factory. Press the ‘Settings’ button on the
Operating Panel for 3 seconds to awake the mower.
• Connect the DC Cable coming from the Power Box to the
Charging Socket at the rear side of Robomow.
• Conrm the Battery LED on Robomow is blinking, which
is an indication of charging.
• Leave Robomow connected to the Power Box while
completing the setup of the Perimeter Wire.
4.2 Perimeter Wire Setup
Before you start the setup, you should have a plan for the Perimeter Wire layout and for the location of the Base
Station. Your plan should consider the following:
o What type of lawn areas does your lawn have?
(Main Zone Only / Main + Sub-Zones / Separated Zones / combination of types).
o Are there protected or excluded areas on the lawn? (Perimeter Islands).
o Are there any slopes that Robomow should avoid?
o Are there edges of pools, ponds, cliffs etc., that need an extra distance from the Perimeter Wire?
Hammer Combination Piers
Small at and Philips
Screwdrivers

Robomow MC300 Specifications

General

Type	Robotic lawn mower
Cutting width	280 mm
On/off switch	Yes
Cutting system	-
Recommended lawn area	300 m²
Maximum cutting height	60 mm
Minimum cutting height	15 mm
Grass collecting volume	- L
Battery type	LiFePO4
Power source	Battery
Battery voltage	26 V
Battery technology	Lithium

Weight and Dimensions

Depth	460 mm
Width	630 mm
Height	210 mm
Weight	11100 g