Robomow MC300 Operating Manual

21
If the Narrow Pass is wider than 2m, and you want Robomow to mow the area inside the Narrow Pass, then you
can set the wire as shown in the gure below. Such a setup allows the mower to mow inside the Narrow Pass while
mowing the inner part of the lawn, but prevents it from crossing between the zones.
Sub-Zone
Main-Zone
10cm
30 cm
Perimeter
Island
As long as needed
when keeping 10cm
from both sides
4.4 Fastening Perimeter Wire to the Ground
o Before starting to lay the Perimeter Wire, it is recommended to cut the grass where the wire is to be laid.
It will then be easier to attach the wire to the ground. The risk that the mower will damage the wire during
the operation is reduced.
o It is not necessary to bury the Perimeter Wire, though you may do so, up to 5 cm (2 inches) deep.
o Pull the wire tight while hammering the peg all the way into the ground.
WARNING !
Protect your eyes! Protect your hands!
Use proper eye protection and wear appropriate work gloves when hammering the pegs.
Hard or dry ground may cause pegs to break when driving them in.
o Use a hammer to insert the pegs into the ground.
o Insert the pegs at distances that will keep the wire
down below the grass level and prevent the wire from
becoming a tripping hazard (approximately 75 cm
between pegs).
• The wire and the pegs will gradually become
invisible under the growth of new grass.
o If an additional wire is required in order to complete
the setup, connect it using the water-proof wire
connectors supplied with Robomow. (See Section
11.4 – Splicing the Perimeter Wire).
A. At the point you want the mower
to
start driving towards the Sub-Zone
start to set the Narrow Pass.
B. Set an Island at the middle of the
Narrow Pass and keep a distance
of 10 cm (4 inches) from the
Perimeter Wire.
C. The island dimensions should be
30 cm along the side and as wide
as needed, keeping 10 cm from
both sides.
D. After completing the setup of the
wire in the Sub-Zone, make sure
you keep 10 cm (4 inches)
between the wire and the island
on the way back to the Main Zone.
Sub-Zone
Perimeter
Island
As long as needed
when keeping 10cm
from both sides

Robomow MC300 Specifications

General

Type	Robotic lawn mower
Cutting width	280 mm
On/off switch	Yes
Cutting system	-
Recommended lawn area	300 m²
Maximum cutting height	60 mm
Minimum cutting height	15 mm
Grass collecting volume	- L
Battery type	LiFePO4
Power source	Battery
Battery voltage	26 V
Battery technology	Lithium

Weight and Dimensions

Depth	460 mm
Width	630 mm
Height	210 mm
Weight	11100 g