Robomow MC300 Operating Manual

37
8. Charging
8.1 Charging During the Season
The Base Station is the primary charging source when Robomow is docked and will maintain the optimal battery
charge while awaiting departure.
8.2 Charging Out of Season
During out of season months, such as winter, it is required to:
• Fully charge the battery in the Base Station till
the Battery indicator is green and lit constantly.
LED indicators for charging:
- Red is lit constantly – Charge the battery.
- Green is blinking – During battery charging.
- Green is lit constantly – Baery is fully charged.
• Remove Robomow from its Base Station. Turn
the Safety Switch off and store the mower in a
room temperature.
• If the mower is stored for more than 3 months,
it is required to recharge the battery every 3
months till the Battery indicator shows it is fully
charged.
• The charging can be done in one of the following
options:
1. Plac e the mower in the Base Station for charging.
2. Conne ct Robomow directly to the Power Box as follows:
- Disconnect the DC Cable coming from the Power Box
to the 15m Extension Cable and connect it to the
rear side of the mower as . in the gure to the right.
• Once the season starts, just place Robomow in
its Base Station to begin automatic operation.
9. Troubleshooting and User Messages
9.1 General Error Codes
Robomow continuously monitors its operation. It produces error codes to assist you in running it smoothly.
A sticker containing the most common error codes is provided in the box. You can place it on the mower for your
convenience.
E9* (See Troubleshooting in Manual) represents
stops and error that are not very common, and
thus they are not shown in the above Error Code
Table. If E9 is displayed, press the RIGHT arrow
to receive the Error Code reason, for which
the mower has stopped and refer to the User
Manual for more details.
• Usually, if the mower stops, an error code is
displayed. This display stays on for 5 minutes. If
you arrive later than those 5 minutes, the display
will be blank.
• To wake Robomow up and see the last error
Rombow Error Codes Table
E 1 Stuck in Place
E 2 Mower is Outside
E 3 No Wire Signal
E 4 Check Power
E 5 Check Blade / Cutting Height
E 6 Check Drive
E 7 Front Wheel Problem
E 8 Decrease Inactive Time
E 9* See Troubleshooting in Manual
E5XX Call Support

Robomow MC300 Specifications

General

Type	Robotic lawn mower
Cutting width	280 mm
On/off switch	Yes
Cutting system	-
Recommended lawn area	300 m²
Maximum cutting height	60 mm
Minimum cutting height	15 mm
Grass collecting volume	- L
Battery type	LiFePO4
Power source	Battery
Battery voltage	26 V
Battery technology	Lithium

Weight and Dimensions

Depth	460 mm
Width	630 mm
Height	210 mm
Weight	11100 g