Chapter 6-1
Charging
Chapter 6 Charging
Proper charging of the Power Pack is of utmost importance!
Failure to follow the charging guidelines will result in poor performance
and a short Power Pack life.
Shock, injury, electrocution hazard!
Never use a Power Supply when the leads are damaged.
Use only the recommended Power Supply for your Robomow.
Do NOT pack the Power Supply inside a plastic bag, as it will
over-heat.
Robomow will be automatically recharged at its Base Station at
the end of all mowing sessions. It is best for the Power Pack to remain
plugged in at all times of non-use, throughout the mowing season.
There is absolutely NO need for concern: no over-charging, no over-
heating and no damaging the Power Pack.
After completion of all daily cutting sessions it is very important
to bring Robomow to its storage area and plug it into the charger. This
should be done as soon as possible, preferably within 6 hours from the
time it stopped.
Charging time is approximately 20 hours, depending on conditions.
6.1 Charging at the Base Station
The Base Station is the primary Charging Station when Robomow is
docking
P When the Power Pack is being charged at the Base Station one of
the following screens is displayed:
) If Robomow is docked and a Weekly Program is set:
) If Robomow is docked and a Weekly Program is NOT set.
Or: if Auto Depart is turned off:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
