Chapter 2-7
Base Station and Perimeter Wire Setup
2.5 Assembling the Base Station
2.5.1 Laying and fastening power cord
Safety
Avoid injury!
The power cord should always be securely fastened to the ground!
It should never present a tripping hazard.
The power cord should cross over soft surfaces ONLY.
It should NOT cross over hard surfaces (e.g. sidewalk, driveway)
where it cannot be securely fastened.
Base Station assembly
P Fence to Station base:
Align the three slots on the fence with the three tabs on the base. Push
the fence firmly down onto the base until it snaps into place.
To Next Page
Loading...
