Robustel GoRugged R3000-3P User Guide
36
3.16 Configuration -> Firewall
This section allows users to set the firewall parameters.
Filter Basic Settings @ Firewall
Enable to allow users to access the router remotely on the internet side via HTTP.
Remote Access Using
TELNET
Enable to allow users to access the router remotely on the internet side via
Telnet.
Enable to allow users to access the router remotely on the internet side via
SNMP.
Enable to make router reply the Ping requests from the internet side.
Enable to defend dos attack. Dos attack is an attempt to make a machine or
network resource unavailable to its intended users.
Select from “Accept” and “Drop”.
Accept: Router will reject all the connecting requests except the hosts which fit
the filter list.
Drop: Router will only accept the connecting requests from the hosts which fit
the filter list.
Click “Add” to add a filter list.
Select from “Accept” and “Drop”.
Accept: Router will reject all the connecting requests except the hosts which fit
this filter rule.
Drop: Router will only accept the connecting requests from the hosts which fit
this filter rule.
Defines if access is allowed from one or a range of IP addresses which are defined
by Source IP Address, or every IP addresses.
Defines if access is allowed from one or a range of port which is defined by
Source Port.
Defines if access is allowed to one or a range of IP addresses which are defined
by Target IP Address, or every IP addresses.
Defines if access is allowed tone or a range of port which is defined by Target
To Next Page
Loading...
Need help?
General
