Robustel GoRugged R3000-3P User Guide
RT_R3000-3P_UG_v01.03 1
Confidential
Chapter 5. Introductions for CLI
5.1 What’s CLI and hierarchy level Mode
The R3000-3P command-line interface (CLI) is a software interface providing another way to set the
parameters of equipment from the console or through a telnet network connection. Before using them
better a few of details will be introduced on four different CLI hierarchy level modes which have different
access rights :
User exec mode—The command prompt “>” shows you are in the user mode , in this mode user can
only use some simple commands to see the current configuration and the status of the device, or enter
the “ping” command to troubleshoot the network connectivity.
Privileged exec mode—When you enter Privileged mode ,the prompt will change to “#” which user can
do not only what is allowed in the user exec mode but also the new additions like importing and
exporting for files , system log , debug and so on .
Global configuration mode—The global configuration mode with prompt “<config>#” allows user to
add ,set ,modify and delete current configuration .
Interface mode—Prompt “<config-xx>” means in this mode we can set both IP address and mtu for
this interface.
Following is a relationship diagram about how to access or quit among the different modes :
USER EXEC MODE:
R3000-3P Configure Environment
Username: admin
Password: *****
R3000-3P> ? //check what commands can be used in user exec mode
enable Turn on privileged commands
exit Exit from current mode
ping Ping test
reload Halt and perform a cold restart
tracert Tracert test
show Show running system information
To Next Page
Loading...
Need help?
General
