USER'S MANUAL
8 of 28
2.4 Intended use
The espresso machine is designed for the professional prepa-
ration of hot beverages such as tea, cappuccinos, coffee in
long, short and espresso variants, etc. The machine is not in-
tended for domestic use, but for professional use only.
The machine may be used under all conditions envisaged,
contained or described in this documentation; any other con-
ditions must be considered hazardous. The machine must be
installed in places where access is restricted to qualied per-
sonnel who have received appropriate training (bars, restau-
rants, etc.).
Permitted uses
These are all those which comply with the technical charac-
teristics, operations and uses described in this documentation
and do not endanger the user's safety or cause damage to
the machine or the environment.
All uses not specically indicated in this manual
are prohibited and must be expressly authorised
by the manufacturer.
Intended uses
The machine is designed exclusively for professional use. The
use of products/materials other than those specied by the
Manufacturer, which may create damage to the machine and
dangerous situations for the operator and/or persons close to
the machine, is considered incorrect or improper.
Contraindications for use
The machine must not be used:
• for uses other than those set out in this paragraph, for
uses other than or not mentioned in this Manual;
• using material other than that indicated in this Manual;
• with bypassed or malfunctioning safety devices.
Incorrect use of the machine
The type of use and performance for which this machine
has been built impose a series of operations and procedures
that cannot be changed without prior agreement with the
manufacturer. All permitted behaviour is contained in this
documentation, any operation not listed and described in this
documentation is considered not possible and therefore dan-
gerous.
Unintended uses
The only permitted uses are described in the Manual, any
other use is considered not possible and therefore dangerous.
General safety measures
The Technician must be familiar with the risks of accidents,
the devices provided for safety and the general rules on acci-
dent prevention laid down by EU directives and the legislation
of the country where the machine is installed.
The Technician must be familiar with the operation of all de-
vices on the machine. He must also have read and fully un-
derstood this Manual. Maintenance work must be carried out
by the technician after the machine has been properly pre-
pared. Tampering with or unauthorised replacement of one or
more parts of the machine, the adoption of accessories that
change its use and the use of materials other than those rec-
ommended in this manual, may become a risk of injury.
To Next Page
Loading...
