USER'S MANUAL
23 of 28
9. DISPLAY WARNINGS
PROBE ALARM
Cause
Boiler temperature sensor fault.
Description/Action
By pressing the button, the ma-
chine resumes operation, inhibiting
only the faulty unit.
Switch off the machine and contact
the technician.
BOILER TRANSDUC-
ER ALARM
Cause
Faulty machine pressures
Description/Action
Switch off the machine and contact
the technician.
LINE TRANSDUCER
ALARM
Cause
Faulty machine pressures
Description/Action
Switch off the machine and contact
the technician.
TIME-OUT
Cause
Boiler water lling time too long.
Description/Action
Check the opening of the water
mains tap.
Switch the machine off and on again.
If the signal persists after a few at-
tempts, switch off the machine and
contact the technician.
DOSING UNIT
ALARM
Cause
Electronic volumetric control failure.
Description/Action
Stop dispensing by pressing the dose
button.
Switch off the machine and contact
the technician.
MAINTENANCE
REQUIRED
Cause
Request to perform maintenance.
Description/Action
Silence the alarm by pressing the
button on the rst group. Contact the
technician for maintenance.
FILTER ALARM
Cause
Water lter replacement required.
Description/Action
Silence the alarm by pressing the
button in the rst group. Replace the
lter.
10. SPARE PARTS
The replacement of components and/or parts of the machine
must only be carried out by the Technician.
Under no circumstances is the User authorised to
replace components and/or parts of the machine.
11. DECOMMISSIONING
It is necessary to put the machine out of service by requesting
the intervention of a technician as the equipment must be
disconnected from the electrical and hydraulic mains, and all
internal circuits must be emptied of water.
Commissioning of the machine after this period may only be
carried out by a technician.
Under no circumstances is the User authorised to
put the machine out of service for long periods and
put it back into service.
12. DISMANTLING
The dismantling of the machine must only be carried out by
the Technician.
To Next Page
Loading...
