Rocket DOPPIA 2GR - Steam Dispensing; Hot Water Dispensing

USER'S MANUAL
14 of 28
6.6 Steam dispensing
For optimal foaming, it is recommended to follow these sim-
ple rules:
• Only heat the amount of milk you intend to use. Once
heated, it must be poured entirely from the jug and not
heated again;
• froth milk from a temperature of about 4°C.
In any case, the following precautions must always be followed
before dispensing steam.
Handle the steam wand carefully using the anti-
scald rubber. Avoid directing steam towards hands
or other parts of the body. Do not touch steam
wands with bare hands; use appropriate PPE.
In order to keep the terminals of the steam
wands in perfect working order, it is recom-
mended to carry out a short no-load draw at
the end of each use.
Keep the terminals constantly clean with a
cloth moistened in lukewarm water. Leave the
steam wand immersed in the milk only for the
time necessary for heating.
Do not open the steam tap with the steam
wand immersed in milk and the machine
switched off as this would suck the milk into the
pipes.
• Immerse the steam wand in the liquid to be heated;
• move the tap lever downwards to start steam dispensing;
Steam
dispensing
• the amount of steam dispensed will be proportional to the
movement of the lever;
• To end dispensing, move the lever back upwards.
6.7 Hot water dispensing
Danger of burns. Avoid directing hot water to-
wards hands or other parts of the body. Do not
touch hot water nozzles with bare hands; use
appropriate PPE.
The hot water dispensing mode is different for each type of
machine, so you must follow the instructions according to the
model you are using.
HOT WATER DISPENSING
• Place the jug under the hot water spout;
• press the water button for the desired dose (short or long)
and wait for hot water to be dispensed;
• the machine dispenses a programmed amount of hot wa-
ter; to stop the delivery in advance, press the water dis-
pensing button again.
Pressing the two water buttons simultaneously
activates manual dispensing; the machine dis-
penses water as long as the 2 buttons remain
pressed.
HOT WATER PROGRAMMING
The machine is already programmed by the factory. If you
wish to change the hot water doses, proceed as follows:
• Place the jug under the hot water nozzle;
• press
for at least 5 seconds until all LEDs on the but-
ton panel light up;
• press the dose button you wish to program, e.g.
(dur-
ing programming the button ashes);
• to conrm the dose, again press
• if desired, repeat the operation for the other dose key;
• the machine automatically exits programming after a few
seconds, wait until the LED on the button goes out
.
If dose programming does not take place, this
means that it is disabled, contact the techni-
cian.