Publication 2711C-UM001C-EN-P - September 2009 37
Configuration Mode Chapter 2
Change the Startup Application
You can select or change the application that runs on the terminal
each time the terminal starts up. You must also select the storage
location of the application. The options are internal storage of the
terminal, USB flash drive, SD card, or PC storage.
Follow these steps to select or change the startup application using
the PanelView Explorer Startup window.
1. Go to the PanelView Explorer Startup window.
2. Click the Terminal Settings link.
3. Click the System Information tab.
4. Select the name of the startup application from the Startup
Application pull-down list.
5. Click Apply, or click Cancel to restore the current setting.
IMPORTANT
If the application list is empty, the run, copy, delete, and set as
startup functions will not perform any action.
To Next Page
Loading...
Need help?
General
