Publication 2711C-UM001C-EN-P - September 2009 87
Troubleshoot the System Chapter 6
Alert 2057 Terminal is running low on application memory
(<Available_Virtual_Memory>bytes).
Please reset the terminal or this may lead to fatal
error.
Alert 2058 Failed setting property: /*S:0 Param1*/::/*S:0
Param2*/, value = /*S:0 Param3*/
Verify the range of the numeric display that uses
the external tag as its write tag is within the range
of a tag (validation should provide a warning if the
range of the tag is greater than the range of a
numeric entry). Make sure that the values of the
state based objects that write to an external tag
are within the range of the tag. Make sure that the
value that written to an external tag matches the
tag type (for example, do not write a non-numeric
string into a numeric tag).
Alert 2059 Failed setting property (/*S:0 Param1*/): /*S:0
Param2*/::/*S:0 Param3*/, value = /*S:0 Param4*/
Verify the range of the numeric display that uses
the external tag as its write tag is within the range
of a tag (validation should provide a warning if the
range of the tag is greater than the range of a
numeric entry). Make sure that the values of the
state based objects that write to an external tag
are within the range of the tag. Make sure that the
value that written to an external tag matches the
tag type (for example, do not write a non-numeric
string into a numeric tag).
Alert 2060 Terminal is running low on RAM
(<Available_RAM>bytes).
Please reset the terminal or this may lead to fatal
error.
Alert 2061 Out of memory: Terminal cannot continue to run
and will be reset.
This is a out of memory critical message.
Dismissing this dialog causes the terminal to reset.
After the terminal resets, try to edit an application
and reduce its size by removing some objects, for
example, user controls, screens, tags, or alarms.
Alert 2055
*
Cannot copy recipe to a loaded application. Please unload application and try again.
Alert 3001 Available memory is too low to run the application. Please try to release some memory or this may lead
to fatal error.
Multilanguage 8193 Language switch ignored. Application was not
configured with new language. An attempt was
made to switch to a language that is not configured
for this application.
Either add the specified language and associated
strings or remove the unconfigured language
selection.
PanelView Component Terminal Alerts
Category ID Description Corrective Action
To Next Page
Loading...
Need help?
General
