Publication 2711P-UM001D-EN-P - September 2005
7-10 Transfer files and Upgrade Firmware
10. Press Finish to start the upgrade.
11. Press Yes to continue the upgrade process. If the terminal was
properly prepared for the upgrade, no applications should be
running.
12. Firmware files are downloaded to the terminal. This may take
several minutes to 15 minutes. When the download is complete,
press OK to reset the terminal.
If other terminals exist on the same Ethernet network, the
following error may display:
"Error registering name on network (may be duplicate). Change
in system Control Panel and try again."
Ignore this error. It will be corrected during the upgrade. Press
OK to acknowledge error and wait for terminal to reset.
TIP
If a USB mouse is available you can
acknowledge the error by selecting OK.
To Next Page
Loading...
Need help?
General
