Parameter Information B-3
Stall Stall Delay 71 SEC 0.0…10.0 0
Ground Fault Gnd Flt Enable 72 Disable
Enable
Disable
Ground Fault Gnd Flt Level 73 A 1.0…5.0 2.5
Ground Fault Gnd Flt Delay 74 SEC 0.1…250.0 0.5
Ground Fault Gnd Flt Inh Time 75 SEC 2…25 10
Ground Fault Gnd Flt A Enable 76 Disable
Enable
Disable
Ground Fault Gnd Flt A Lvl 77 A 1.0…5.0 2.0
Ground Fault Gnd Flt A Dly 78 SEC 0…250 10
PTC PTC Enable 79 Disable
Enable
Disable
Phase Reversal Phase Reversal 80 Disable
Enable
Disable
Restart Starts Per Hour 81 0…99
Restart Restart Attempts 82 0…5 2
Restart Restart Delay 83 SEC 0…60 0
Comm Masks Logic Mask 87 8-bit binary
DataLinks Data In A1 88
DataLinks Data In A2 89
DataLinks Data In B1 90
DataLinks Data In B2 91
DataLinks Data In C1 92
DataLinks Data In C2 93
DataLinks Data In D1 94
DataLinks Data In D2 95
DataLinks Data Out A1 96
DataLinks Data Out A2 97
DataLinks Data Out B1 98
DataLinks Data Out B2 99
DataLinks Data Out C1 100
DataLinks Data Out C2 101
DataLinks Data Out D1 102
DataLinks Data Out D2 103
Motor Data Motor ID 104 0…65535 0
Motor Data CT Ratio 105 1…1500
Motor Data MV Ratio 106 1…10000
Basic Set Up Aux1 Config 107 Normal
Up To Speed
External Bypass
Normal
Basic Set Up Fault Contact 108 NO
NC
NO
Basic Set Up Alarm Contact 109 NO
NC
NO
Table B.1 Parameter List (Continued)
Group
Parameter
Description
Parameter
Number
Units
Min./
Max.
Default
Settings
User
Settings
To Next Page
Loading...
Need help?
General
