Maintenance
Repair
64 MagneMotion
Rockwell Automation Publication MMI-UM037A-EN-P - April 2020
Repair
If a component of the MagneMover LITE transport system malfunctions, see Troubleshooting
on page 53 in this manual for diagnostic procedures. If these procedures are not adequate to
determine the source of the problem, see Contact ICT Customer Support on page 63. Once the
failed unit has been identified, a replacement unit can be ordered and installed as directed in
the MagneMover LITE User Manual.
NOTE: The components of the MagneMover LITE transport system are designed for easy
replacement. Motors, controllers, and other modules do not contain any user service-
able parts.
NOTICE
Only a qualified service representative can service the components of the
MagneMover LITE transport system. Any attempt to open the transport sys-
tem modules by anyone other than a qualified MagneMotion service repre-
sentative voids the warranty.
Table 14: MagneMover LITE Repair Procedures
Component Maintenance Action Page #
MagneMover LITE Trans-
port System
Replace RS-422 Motors 66
Programming RS-422 Motors 68
Replace RS-422 Motors with Ethernet Motors 69
Replace Ethernet Motors 73
Programming Ethernet Motors 76
Separating Magnet Arrays 77
Puck Replace Pucks 78
Replace Glide Puck Wear Surfaces 81
Replace Tandem Glide Puck Wear Surfaces 85
Replace Wheeled Puck Wear Surfaces 91
Replace Tandem Wheeled Puck Wear Surfaces 94
Power Supply Replace Power Supply Fuses 101
To Next Page
Loading...
Need help?
General
