106 of 136
2. Click on the outlined numeric entry to display keypad to change the speed reference of the drive.
The numeric box performs a dual purpose. It displays the drive feedback, but can also be used to enter
information. After you click the “Enter” button the value is stored but not displayed. Once the motor is
spinning, the value will be updated.
3. Type a value between 0 Hz and 60 Hz and press the “Enter” ( ) button on the keypad to confirm.
The faceplate will technically allow a higher value to be entered, but the drive will limit to 60 Hz in any case.
4. Click the “Start” button in the PF525 faceplate.
The drive will start turning the motor at the commanded speed. You can see the speed feedback changing in the numeric
box on the faceplate.
5. After making the motor come to reference speed, click the “Stop” button in the PF525 faceplate.
To Next Page
Loading...
Need help?
General
