115 of 136
6. The picture below shows how to enable or disable ADC for the PowerFlex 525 drive and its peripherals (if
applicable). Click the check box that his highlighted below to enable ADC.
7. Click the “Apply” button in the Automatic Device Configuration window and close the window.
In order for setting changes to take effect, you must click the “Apply” button before closing the window with
the [X] at the top corner.
8. Click the “OK” button to close the Module Properties window.
9. Repeat steps 3-8 for the “PowerFlex 755-EENET PF755_Drive”.
Note: When enabling ADC for the PowerFlex 755 drive and its peripherals, uncheck the checkbox for
Port 6: 20-750-S1 Safe Speed Monitoring to disable ADC for the Safety peripheral card.
10. Click on “Communications” in the menu bar and select “Who Active”.
The Who Active window will appear.
To Next Page
Loading...
Need help?
General
