69 of 136
Click Next > to the AutoTune step of the wizard.
35. The AutoTune step is next. This step is where you can use the automatic tuning algorithms (AutoTune). When
running these algorithms, the drive energizes the motor and makes measurements, which are used to make parameter
settings.
AutoTune tests are not needed for this example; however they can be ran if you desire. If you do perform the AutoTune,
please note the test status:
Leaving the AutoTune page while the test is in process will abort the test, faulting the drive. Do not leave AutoTune page
until the test is complete:
Note: In some cases, an Over Speed Fault may occur during a Rotate Tune. Just acknowledge it and move on with the
lab.
Click Next > until you reach the Ramp Rates / Speed Limits step of the wizard.
Note: Clicking < Back, Next >, or leaving step by any means will abort the test.
To Next Page
Loading...
