Roger Technology CTRL - Page 48

EN
86
-HIRXMƼGEXMSRRYQFIV
8LIMHIRXMƼGEXMSRRYQFIVGSRWMWXWSJXLIZEPYIWSJXLITEVEQIXIVWJVSQQ to Q.
N.B.8LIZEPYIWWLS[RMRXLIXEFPIEVIMRHMGEXMZISRP]
Q
HW version
)\EQTPI
Q
Year of manufacture
Q
Week of manufacture
Q
Serial number
Q
Q
Q
FW version
Q
RS485 serial communication version
View manoeuvre counter
The number consists of the values of the parameters from R
to R multiplied by 100.
N.B.8LIZEPYIWWLS[RMRXLIXEFPIEVIMRHMGEXMZISRP]
R
Manoeuvres performed
)\EQTPIx100 = 1,234,500 manoeuvres
R
R
View manoeuvre hour counter
The number consists of the values of the parameters from K to K.
N.B.8LIZEPYIWWLS[RMRXLIXEFPIEVIMRHMGEXMZISRP]
K
Manoeuvre hours
)\EQTPI = 123 hours
K
View control unit days on counter
The number consists of the values of the parameters from G to G.
N.B.8LIZEPYIWWLS[RMRXLIXEFPIEVIMRHMGEXMZISRP]
G
Days with unit switched on
)\EQTPI = 123 days
G
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active (&3=TEVEQIXIVWQE]FIZMI[IHFYXXLIZEPYIW'%2238FIQSHMƼIH
Only a single password is used to control access to the barrier automation system.
WARNING: Contact the Technical Support Service if you lose your password.
N.B.: This parameter is not visible for the SLAVE barrier.
3
3
3
3
Password activation procedure:
• Enter the desired values for parameters 3, 3, 3 and 3.
• Use the UP
a
and/or DOWN
b buttons to view parameter &3.
• Press and hold the + and - buttons for 4 seconds.
• 8LIHMWTPE]ƽEWLIWXSGSRƼVQXLEXXLITEWW[SVHLEWFIIRWEZIH
• Switch the control unit off and on again. Check that password protection is activated (&3=).
Temporary unlock procedure:
• Enter the password.
• Check that &3= .
Password cancellation procedure:
• Enter the password (&3=).
• Save the values 3, 3, 3, 3 = 
• Use the UP
a
and/or DOWN
b buttons to view parameter &3.
• Press and hold the + and - buttons for 4 seconds.
• 8LIHMWTPE]ƽEWLIWXSGSRƼVQXLEXXLITEWW[SVHLEWFIIRGERGIPPIHXLIZEPYIW3,3,3 and 3
and indicate that no password is set).
• Switch the control unit off and on again (&3=).
&3
Password change protection

Protection deactivated.

Protection activated.