Preparing for Use
R&S
®
FSVA3000/R&S
®
FSV3000
23Getting Started 1330.8073.02 ─ 03
4.2.3.1 Automatic Login Function
When shipped, the instrument automatically logs on the default "Instrument" user
to Windows 10 using the default password.
Switching users when using the automatic login function
Which user account is used is defined during login. If automatic login is active, the
login window is not displayed. However, you can also switch the user account to
be used when the automatic login function is active.
1. Select the "Windows" icon in the toolbar to access the operating system of the
R&S FSV/A (see also Chapter 4.2.4, "Accessing the Start Menu",
on page 24).
2. Press [CTRL + ALT + DEL], then select "Sign out".
The "Login" dialog box is displayed, in which you can enter the different user
account name and password.
Deactivating the automatic login function
To deactivate the automatic login function, perform the following steps:
1. Select the "Windows" icon in the toolbar to access the operating system of the
R&S FSV/A (see also Chapter 4.2.4, "Accessing the Start Menu",
on page 24).
2. In the "Start" menu, select "Run".
The "Run" dialog box is displayed.
3. Enter the command C:\R_S\INSTR\USER\NO_AUTOLOGIN.REG.
4. Press the [ENTER] key to confirm.
This command deactivates the automatic login function. The next time you
switch on the instrument, the operating system prompts you to enter your user
name and password before it starts the firmware.
Windows Operating System
To Next Page
Loading...
