Preparing for Use
R&S
®
FSVA3000/R&S
®
FSV3000
38Getting Started 1330.8073.02 ─ 03
The secure user mode setting and automatic login is automatically deactivated
when the "Instrument" user logs on. The "SecureUser" is no longer available.
For administrators ("Instrument" user), the secure user mode setting is available
in the general system configuration settings ([Setup] key > "System Configura-
tion" softkey > "Config" tab > "Secure User Mode": "ON", see the R&S FSV/A
User Manual).
Remote control
Initially after installation of the R&S FSV/A-K33 option, secure user mode must be
enabled manually once before remote control is possible.
This is necessary to prompt for a change of passwords.
Protecting Data Using the Secure User Mode
To Next Page
Loading...
