Preparing for Use
R&S
®
FSVA3000/R&S
®
FSV3000
37Getting Started 1330.8073.02 ─ 03
Restricted operation
Since permanent storage is not possible, the following functions are not available
in secure user mode:
●
Firmware update
●
Activating a new option key
Furthermore, since the "SecureUser" used in secure user mode does not have
administrator rights, administrative tasks such as LAN configuration and some
general instrument settings are not available. Refer to the description of the basic
instrument setup ([SETUP] menu) to find out which functions are affected.
Activating and deactivating secure user mode
Only a user with administrator rights can activate the secure user mode. Once
activated, a restart is required. The special user "SecureUser" is then logged on
to the R&S FSV/A automatically (using the automatic login function, see Chap-
ter 4.2.3.1, "Automatic Login Function", on page 23). While the secure user mode
is active, a message is displayed in the status bar at the bottom of the screen.
Secure Passwords
By default, the initial password for both the administrator account ("Instru-
ment") and the "SecureUser" account is "894129". When the secure user
mode is activated the first time after installation, you are prompted to
change the passwords for all user accounts to improve system security.
Although it is possible to continue without changing the passwords, it is
strongly recommended that you do so.
You can change the password in Windows 10 for any user at any time via:
"Start > Settings > Account > SignIn Options > Password > Change"
To deactivate the secure user mode, the "SecureUser" must log off and the
"Instrument" user (administrator) must log on.
Switching users when using the automatic login function
In the "Start" menu, select the arrow next to the "Shut down" button and
then "Log off".
The "Login" dialog box is displayed, in which you can enter the different
user account name and password.
Protecting Data Using the Secure User Mode
To Next Page
Loading...
