Instrument Tour
R&S
®
FSVA3000/R&S
®
FSV3000
49Getting Started 1330.8073.02 ─ 03
Connect headphones equipped with a miniature jack plug to the AF Out female
connector. Set the output voltage using the "Volume" control above the female
connector.
Risk of hearing damage
Before putting on the headphones, make sure that the volume setting is not
too high to protect your hearing.
5.1.13 Noise Source Control / Power Sensor
The LEMOSA female connector is used to connect smart noise sources or
Rohde & Schwarz power sensors. For a detailed list of supported noise sources
and power sensors, see the data sheet.
Using power sensors requires option R&S FSV3-K9.
For details on configuring and using noise sources and power sensors, see the
user manual.
5.1.14 Trigger Input / Output
Use the female Trigger 1 Input/Output connector to input an external trigger or
gate data. Thus, you can control the measurement using an external signal. The
voltage levels can range from 0.5 V to 3.5 V. The default value is 1.4 V. The typi-
cal Input impedance is 10 kΩ.
The rear panel provides two more Trigger Input / Output connectors, see
Chapter 5.2.7, "Trigger 2/3 In/Out", on page 53.
5.1.15 RF Input 50 Ohm
Connect a device under test (DUT) to the R&S FSV/A to provide RF input which
is then analyzed in an RF measurement. Connect the DUT to the "RF Input" on
the R&S FSV/A via a cable equipped with an appropriate connector.
Front Panel View
To Next Page
Loading...
