Instrument Tour
R&S
®
FSVA3000/R&S
®
FSV3000
53Getting Started 1330.8073.02 ─ 03
Short-circuit hazard
Always observe the designated pin assignment. A short-circuit can damage
the port.
5.2.7 Trigger 2/3 In/Out
The additional female BNC Trigger 2 In/Out connector and the optional Trigger 3
(output) connector allow the R&S FSV/A to receive additional external signals or
to provide signals to another device. The signals are TTL compatible (0 V / 5 V).
You control the connector usage in the "Trigger" settings ([Trigger] key).
5.2.8 Video Output
The female BNC connector can be used to provide video output (1 V).
For details, see the user manual.
5.2.9 IF Output
The female BNC connector can be used to output the intermediate frequency (IF).
For details, see the user manual.
5.2.10 GPIB Interface
The GPIB interface is in compliance with IEEE488 and SCPI. A computer for
remote control can be connected via this interface. To set up the connection, a
shielded cable is recommended. This interface is part of the "Additional Interfa-
ces" hardware option.
For more details, refer to "Setting Up Remote Control" in the R&S FSV/A user
manual.
Rear Panel View
To Next Page
Loading...
