Device disassembly and cleaning
Please perform the following cleaning steps when the power is off!
Disassembly and cleaning of rolling brush components
Step 1: Disassemble the rolling brush
Turn the main unit over, li the buckle and take out the rolling brush cover, and then take out
the rolling brush;
Buckle
Step 2: Clean the rolling brush
Use a cleaning brush to pick up and cut off the hair and fibre aached to the rolling brush, separate
them from the rolling brush, and clean the surface dirt. It is recommended to replace the rolling
brush every 6-12 months.
1. Turn off the power before replacing the rolling brush;
2. The cleaning brush has sharp blades used to cut through tangled debris that is difficult to clean. Keep the cleaning brush out of reach of children.
Caution
11
EN
To Next Page
Loading...
