Roland GX-24 - Page 31

3-2 If You're Using a Windows
Chapter 3: Installing/Uninstalling Software
29
Installing CutStudio
Install the Windows-based cutting program "CutStudio."
➊
Display the setup menu of the Roland GX-24 Soft-
ware Package.
➋
Click [Install].
The setup window appears.
➌
Thereafter, follow the instructions in the messages to complete installation and setup.
Next, you install the operation manuals.
Installing the Operation Manuals
➊
Display the setup menu of the Roland GX-24 Soft-
ware Package.
➋
Click [Install].
The setup window appears.
➌
Thereafter, follow the instructions in the messages to complete installation and setup.
➍
At the setup menu, go to the upper right and click the [X] to close the window.
This completes the installation and setup for the software.
Installing CutStudio Plug-in
For information about how to install and set up the CutStudio Plug-in, refer to the "CutStudio Plug-in for Adobe
Illustrator/CorelDRAW Setup Guide" (electronic-format manual).