Roland GX-24 User Manual

35
Chapter 4:
Performing Cutting
This describes basic cutting operations under Windows, using the included
test-use material in the examples of cutting operations. It also describes
the main operations when using other materials. For other operations not
covered in this chapter, refer to the "GX-24 Reference Guide" (electronic-
format manual).
If you're using a Macintosh, refer to the "Macintosh Cutting Guide" (elec-
tronic-format manual).

Roland GX-24 Specifications

General

Cutting Speed	Up to 20 inches/sec (500 mm/sec)
Distance Accuracy	±0.004 inches (±0.1 mm) or less
Repeatability	±0.1 mm (0.0004 in.) or less
Interface	USB
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	5 to 40°C (41 to 104°F)
Operating Humidity	35 to 80% RH (non-condensing)
Software Resolution	0.025 mm/step (0.001 in./step)