4-1 Practicing Cutting Using the Test-use Material
Chapter 4: Performing Cutting
41
2.
Install the blade holder.
➊
Loosen the screw of the cutting carriage.
➋
Support the screw from below and insert the
blade holder.
If installed without supporting the screw in this way,
cutting quality may become poor.
➌
Tighten the screw.
Tug the blade holder upward to make sure it does not
come loose.
This completes the procedure for installing the blade. Go on to "Step 3: Optimizing the Cutting Quality for the Mate-
rial."
☞
p 42 "Step 3: Optimizing the Cutting Quality for the Material"
Cutting carriage
Screw
Support it from below.
Insert until the collar is
flush with the surface.
To Next Page
Loading...
