Button# # # (Square wave/Asymmetrical pulse wave).!
[SAW/RAMP] Button # !
[SUB] Button# # Turns the sub-oscillator on/off.!
[SUB] Slider# # Adjusts the volume of the sub oscillator. !
[NOISE] Slider# # Adjusts the volume of the noise. !
5 HPF%
This is a high-pass filter that passes the high frequencies and cuts the low frequencies. !
CONTROLLER ## EXPLANATION!
[FREQ] slider # # Specifies the cutoff frequency of the high-pass filter. # # # #
###Frequency components below the cutoff frequency are cut. !
6 VCF%
This is a low-pass filter that passes the low frequencies and cuts the high frequencies. !
CONTROLLER ## EXPLANATION!
[FREQ] slider # # Specifies the cutoff frequency of the low-pass filter. # # # #
# # # Frequency components above the cutoff frequency are cut, !
# # # making the sound mellower.%
[RES] slider # # Resonance boosts the sound in the region of the filter's cutoff frequency.%
# # # Higher settings produce stronger emphasis, creating a distinctively “synthesizer- !
###like” sound. !
[POLARITY] switch # Selects the polarity (direction) of the envelope.!
[ENV] slider # # Adjusts the depth by which the 8 ENV (envelope) controls the cutoff frequency. !
[LFO] slider # # Uses the 3 LFO to vary the cutoff frequency.!
[KYBD] slider # # Adjusts the way in which the pitch of the note affects the cutoff frequency (key !
# # # follow) when using the keyboard to control cutoff frequency. If this slider is !
# # # moved upward, the cutoff frequency rises as you play higher notes. !
7 VCA%
Here you can adjust the amount of time-varying change (envelope) for the volume. !
CONTROLLER ## EXPLANATION!
[ENV/GATE ] switch # Selects whether the volume is controlled by 8 ENV (envelope) or by the gate #!
# # # signal.%
[LEVEL] slider # # Adjusts the volume of the patch. !
To Next Page
