17
Modulation FX Parameters
27: COMPRESSOR
Flattens out high levels and boosts low levels, smoothing out
uctuations in volume.
L in
R in
L out
R out
Compressor
2-Band EQ
2-Band EQ
Compressor
Parameter Value Explanation
Switch OFF, ON Turns the eect on/o.
Depth Knob
ATTACK,
THRESHOLD,
LEVEL
Species the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Rate Knob
Species the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Attack # 0–127
Sets the time it takes until the level is
compressed after the input exceeds
the Threshold.
Threshold # 0–127
Adjusts the volume at which compres-
sion begins
Post Gain 0–+18 [dB] Adjusts the output gain.
Low Gain -15–+15 [dB] Gain of the low frequency range
High Gain -15–+15 [dB] Gain of the high frequency range
Level # 0–127 Output Level
28: LIMITER
Compresses signals that exceed a specied volume level, preventing
distortion from occurring.
L in
R in
L out
R out
Limiter
2-Band EQ
2-Band EQ
Limiter
Parameter Value Explanation
Switch OFF, ON Turns the eect on/o.
Depth Knob
RELEASE,
THRESHOLD,
LEVEL
Species the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Rate Knob
Species the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Release # 0–127
Adjusts the time after the signal
volume falls below the Threshold Level
until compression is no longer applied.
Threshold # 0–127
Adjusts the volume at which compres-
sion begins
Ratio
1.5:1, 2:1, 4:1,
100:1
Compression ratio
Post Gain 0–+18 [dB] Adjusts the output gain.
Low Gain -15–+15 [dB] Gain of the low frequency range
High Gain -15–+15 [dB] Gain of the high frequency range
Level # 0–127 Output Level