Roland RD-800 - Saving and Managing Live Sets; Saving Live Sets (Live Set Write); Changing Live Set Order (Live Set Swap)

23
Modulation FX Parameters
39: LOFI COMPRESS
This is an eect that intentionally degrades the sound quality for
creative purposes.
L in
R in
L out
R out
Compressor
Lo-Fi
Lo-Fi
Compressor
2-Band
EQ
2-Band
EQ
Parameter Value Explanation
Switch OFF, ON Turns the eect on/o.
Depth Knob
BALANCE,
LEVEL
Species the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Rate Knob
Species the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Pre Filt Type 1–6
Selects the type of lter applied to the
sound before it passes through the
Lo-Fi eect.
1: Compressor o
2–6: Compressor on
LoFi Type 1–9
Degrades the sound quality. The
sound quality grows poorer as this
value is increased.
Post Filter Type OFF, LPF, HPF
Type of lter
OFF: no lter is used
LPF: cuts the frequency range above
the Cuto
HPF: cuts the frequency range below
the Cuto
Post Filter Cuto 200–8000 [Hz] Basic frequency of the Post Filter
Low Gain -15–+15 [dB] Gain of the low range
High Gain -15–+15 [dB] Gain of the high range
Balance #
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the eect sound (W)
Level # 0–127 Output Level
40: BIT CRUSHER
This creates a lo- sound.
L in
R in
L out
R out
Bit Crusher
2-Band EQ
2-Band EQ
Bit Crusher
Parameter Value Explanation
Switch OFF, ON Turns the eect on/o.
Depth Knob
SAMPLE RATE,
BIT DOWN,
FILTER
Species the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Rate Knob
Species the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Sample Rate # 0–127 Adjusts the sample rate.
Bit Down # 0–20 Adjusts the bit depth.
Filter # 0–127 Adjusts the lter depth.
Low Gain -15–+15 [dB] Gain of the low frequency range
High Gain -15–+15 [dB] Gain of the high frequency range
Level 0–127 Output Level