Roland RD-800 - Editing the Sound; Adjusting Tone Color and Character; Using Knobs for Sound Adjustment

20
Modulation FX Parameters
33: 3TAP PAN DELAY
Produces three delay sounds; center, left and right.
L in
R in
L out
R out
Left Tap
Right Tap
Triple Tap Delay
2-Band
EQ
2-Band
EQ
Balance W
Balance D
Balance W
Balance D
Feedback
Center Tap
Parameter Value Explanation
Switch OFF, ON Turns the eect on/o.
Depth Knob
CENTER
FEEDBACK,
BALANCE
Species the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Rate Knob
Species the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Delay Left/Right/
Center (sync sw)
OFF, ON
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner’s manual p. 24).
Delay Left/Right/
Center (msec) #/
Delay Left/Right/
Center (note) #
1–2600 [msec]
Adjusts the time until the delay sound
is heard.
note (p. 31)
Center Feedback
#
-98–+98 [%]
Adjusts the amount of the delay
sound that’s fed back into the eect.
Negative “-” settings invert the phase.
HF Damp
200–8000 [Hz],
BYPASS
Adjusts the frequency above which
sound fed back to the eect is ltered
out (BYPASS: no cut).
Left/Right/
Center Level
0–127 Volume of each delay
Low Gain -15–+15 [dB] Gain of the low frequency range
High Gain -15–+15 [dB] Gain of the high frequency range
Balance #
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the delay sound (W)
Level 0–127 Output Level
34: 4TAP PAN DELAY
This eect has four delays.
L in
R in
L out
R out
Quadruple Tap Delay
Balance W
Balance D
Balance W
Balance D
Delay 1
Delay 2
Delay 3
Delay 4
Feedback
1
2 3
4
L
R
Parameter Value Explanation
Switch OFF, ON Turns the eect on/o.
Depth Knob
DLY 1 FBACK,
BALANCE
Species the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Rate Knob
Species the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Delay 1–4 Time
(sync sw)
OFF, ON
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner’s manual p. 24).
Delay 1–4 Time
(msec)/
Delay 1–4 Time
(note)
1–2600 [msec]
Adjusts the time until the delay 1–4
sound is heard.
note (p. 31)
Delay 1
Feedback #
-98–+98 [%]
Adjusts the amount of the delay
sound that’s fed back into the eect.
Negative “-” settings invert the phase.
HF Damp
200–8000 [Hz],
BYPASS
Adjusts the frequency above which
sound fed back to the eect is ltered
out (BYPASS: no cut).
Delay 1–4 Level 0–127 Volume of each delay
Low Gain -15–+15 [dB] Gain of the low frequency range
High Gain -15–+15 [dB] Gain of the high frequency range
Balance #
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the delay sound (W)
Level 0–127 Output Level