AMPLIFIER ENVELOPE
ATTACK
Specifies the time (attack time) from when the key is pressed until the cutoff frequency reaches the maximum level.
DECAY
Specifies the time (decay time) from when the cutoff frequency reaches the maximum level until it decreases to
the sustain level.
SUSTAIN
Specifies the level (sustain level) that is held after the attack time and decay time have elapsed until the key is
released.
GATE LED
Lit while a note is sounding, or gate is present.
RELEASE
Specifies whether the setting of the amp envelope [DECAY] knob is applied to the release time (the time from
when the key is released until the volume decays to zero).
1, 2: Applied to both the filter and amp envelope.
2: Applied only to the amp envelope.
Off: No release, sound cut immediately.
LFO/GATE
Specifies the signal that controls the amp envelope.
LFO: The LFO controls the amp envelope.
GATE: The Note or Gate controls the amp envelope.
Page 16 of 35 Manual V1.03 for firmware V1.11
To Next Page
Loading...
