PATCH / SEQUENCER / SONG SETUP
• For Patch Setup see page 20
• For Sequencer Setup see page 23
• For Song Setup see page 26
VELOCITY ROUTING
By default the VELOCITY is internally routed to the FILTER CONTOUR of the SE-02. This is how velocity is played or
received via MIDI. This can be changed by selecting PATCH SETUP page [5]
Using the encoder, set amount of velocity generated CONTOUR. Think of it as the master
attitude of the filter with both CUTOFF and EMPHASIS increasing with a positive value.
FIRMWARE UPDATE
Update Procedure:
1)
Connect to Computer
2) Power on while holding [8] Button - A disc image names SE-02 appears on desktop
3) Copy the SE02_UPD.BIN file to the SE-02drive
4) Once the files have been copied, eject the SE-02, then remove the USB cable from the computer.
5) Press the MANUAL button on the SE-02 to start the update procedure.
6) When finished, turn off the power…then on again on the SE-02
NOTE:Allow about 30 seconds to continue the update process after re starting the SE-02. It will seem like
something’s wrong, just a little light blinking. Relax, and take a deep breath. Everything is fine.
FACTORY RESET
1) Power on while holding [1] button
2) Press the green [MANUAL] button
3) When finished, power cycle the SE-02
TUNING CALIBRATION:
1)
Switch to
[PATCH]
Mode
2) Hold [TRANSPOSE] and push in the [VALUE] Knob. Push the [VALUE] Knob again to start calibration
3) Perform the Tuning Calibration again (two times more)
MAIN SPECIFICATIONS
MAXIMUM POLYPHONY 1 Voice
POWER SUPPLY AC Adaptor
CURRENT DRAW 2A
DIMENSIONS 300 (W) x 128 (D) x 45 (H) mm |1113/16 (W) x 5 1/16 (D) x 1 3/4 (H)inches
WEIGHT 950 g | 2 lbs 2 oz
ACCESSORIES Owners Manual, leaflet “using the unit safely”
OPTIONS
Page 28 of 35 Manual V1.03 for firmware V1.11
To Next Page
Loading...
