PRESET SECTION
Unlike the other Roland Boutique synthesizers, the SE-02 has four banks of 128 programmed presets and one
bank of 128 user presets. There’s a total of 640 patches (version 1.09 and up).
BANK A, B and C & D
Pre programmed patches are read only memory and cannot be overwitten. A, B and C bank are direct access
using corresponding button while D Bank is called by pressing 2 times Bank A button. “A” button will blink. Bank
D is available with V1.10 firmware and up.
USER BANK
Each of these 128 patch destinations have sounds in them, but they can be overwritten by the user to store 128
patches for later use, and exchange with other SE-02 users. Only 32 first sounds are fitted when shipped from factory.
MANUAL MODE
In order to listen to the current settings of the knobs on the panel of the SE-02 simply press the MANUAL button.
This will switch from whichever preset is currently selected to report the physical settings of the synthesizer. To
return to the presets select the bank, and desired patch number.
COMPARING PATCHES
To compare the currently-edited patch with a saved patch press the COMP button. Each time you press the button,
you switch between the saved patch (button lit) and the currently-edited patch (button unlit). If there are any
differences between the currently-edited patch and the saved patch, a dot appears in the display, and the entire
content shown in the display blinks.
USING THE COMMON BUTTONS AS A KEYBOARD
You can use the [5] – [16] buttons as a one octave transposable keyboard to play the sound.
1.Press the PLAY button. The [5] –[16] buttons are lit.
2. Press the [5] –[16] buttons to play the keyboard
SHIFTING THE PITCH RANGE
Transpose the keyboard in +/- 1 octave intervals with a range of +3/-3 octaves..
Press the OCT+ button or OCT– button. At one octave, the button is lit; at two octaves, the button blinks slowly; at
three octaves, the button blinks rapidly.
TRANSPOSING THE PITCH
You can transpose the pitch in semitone units in a range of ±1 octaves.
1.Hold down the TRANSPOSE button and press the OCT+ button or OCT– button, or turning the VALUE knob. The
display indicates the transpose value.
2.Press the [TRANSPOSE] button to turn transpose on/off.
Page 8 of 35 Manual V1.03 for firmware V1.11
To Next Page
Loading...
