ENTERING GATES
1. Press the GATE button to make it light.
2. While holding down the step button at which you want to enter a gate, use the [VALUE] knob to select
the gate(10–100).
3. Now you can select a “tie” as a gate input value. By using a tie, you can make a smooth connection to
the next step without applying glide ([GLIDE]). (available from V1.10+)
The display shows the note number.
• If you want to enter the same gate at all steps, press the step buttons where you want to enter the gate; then
hold down the [GATE] button and turn the [VALUE] knob.
GLIDE SETTINGS
1. Press the [GLIDE] button to make it light.
2. Press the step buttons for which you want to apply a glide effect, making them light. The pitch changes smoothly
from each lit step to the next step.
Example when glide is applied on steps 2 to 5, 7 to 8 and 11 to 16
SYNTH PARAMETER VALUES
The values of synth parameters that you change using the knobs and switches can be stored in each step.
1. Press the [PRM] button to make it light.
2. While holding down the step at which you cant to enter a parameter value, operate the knob or switch. The display
indicates the synth parameter value.
• If you press a step button while holding down the [PRM] button, the parameter values of the button you
pressed are erased.
•
If you want to erase all of the parameter values, hold down the [PRM] button and turn the [VALUE]
knob. The display indicates OFF and all values are erased.
•
A lit step button indicates [PRM] on, and an unlit step button indicates [PRM] off.
TRANSPOSING A SEQUENCE
1. Program a sequence you like
2. Set the SYNC settings for the sequencer as you want them
EX: Clocking the SE-02 sequencer from the GATE output of an external sequencer, or other clock source.
3. Set the key trigger (option 3 of the sequencer setup menu) to "TRIGGER"
4. Now when you play a key the sequence will begin and clock from whichever source you've assigned,
and in which ever key you are playing.
PERFORMANCE SETTINGS
1. Press the [PERFORM] button to make it light.
2. Press a step button to select a performance setting.
3. If you pressed step button [8] or [14] - [16] use the VALUE knob to specify the value.
BUTTON PARAMETER VALUE EXPLANATION
[1] - [6] SCALE
1/16 (sixteenth note)
1/8 (eighth note)
1/4 (quarter note)
1/16T (16th note triplet)
1/8T (8th note triplet)
1/4T (quarter note triplet)
Specifies the note length of one step
[8] SHUFFLE -50 - 50 Adjusts the timing of the notes for
even numbered steps
[9] - [12] DIRECTION
—>
<—
<—>
RND
Specifies how the sequencer plays
Forward from the first step
Backward from the last step
Forward from the first step, and then backward
Plays steps randomly
[14] FIRST STEP 1-16 Specifies the step that is played first
[15] LAST STEP 1-16 Specifies the step that is played last
[16] TEMPO 40-300 Specifies the tempo for internal sync
Page 22 of 35 Manual V1.03 for firmware V1.11
To Next Page
Loading...
