SONG SETUP
1. Press the EDIT button and PTN button to make them light (both buttons calls the “SETUP” function)
2. Use the [1] - [5] or [9] buttons to select a parameter, and use the VALUE knob to edit the parameter’s value. The
display indicates the value
BUTTON PARAMETER VALUE/EXPLANATION
[1] DESTINATION
Specifies the output destination of Song.
Int: Internal
E=t: External Device
bot: Both internal and external device
[2] SYNC Specifies the clock to which the sequencer is synchronized.
Int: Internal
n id: MIDI IN
USB: USB MIDI
trg: Trigger In
[3] TEMPO Tempo when sync is defined to Int, from 40 to 400 bpm.
[4] KEY TRIGGER Specifies whether the step sequencer is controlled by the key trigger
OFF: Not controlled
On: Controlled
trn: Controlled by key trigger, or note number (on K25-M only)
[5] LOOP Specifies whether the song plays as a loop.
OFF: does not loop, On: plays as loop (Version V1.10 and up)
[9] CLEAR SONG Click [Value] to confirm or [EXIT] to cancel
3. To save the edited settings, perform the Song Write operation.
Page 26 of 35 Manual V1.03 for firmware V1.11
To Next Page
Loading...
