MWHL
Selects the modulator that is assigned to the LFO of the WHL MIX knob, and specifies the depth of the effect.
F: The effect is applied strongly.
H: The effect is applied weakly.
OFF: No effect is applied.
MODE
Specifies the LFO’s operating mode.
1X: The LFO applies only once.
KEY: The LFO starts at note-on.
FREE: The LFO applies always.
SYNC
Selects whether LFO and DELAY are synchronized with MIDI clock.
Ø: Not synchronized.
L: Only the LFO is synchronized to MIDI clock.
D: Only the DELAY is synchronized to MIDI clock.
LD: Both LFO and DELAY are synchronized to MIDI clock.
PWM LFO
Since version 1.10, an other LFO have been added to SE-02. It allows to modulates pulse width of the 3 oscillators,
using a triangle Wave This LFO applies only on oscillator whose selected waveform is SQUARE WAVE, PULSE
WAVE 1 (wide,) or PULSE WAVE 2 (narrow).
There a 2 parameters to ajust this LFO, accessible from patch Setup menu ( [COMP] + [PLAY] )
[7] LFO PWM RANGE 0-127
[8] LFO PWM DEPTH 0-127
Those parameters are save with other patch settings while write a patch to user memory.
Page 18 of 35 Manual V1.03 for firmware V1.11
To Next Page
Loading...
