24
Turning On/Off the Power
Once the connections have been completed (p. 23), turn on power to your
various devices in the order specified. By turning on devices in the wrong order,
you risk causing malfunction and/or damage to speakers and other devices.
fig.P-001
1
Turn the [VOLUME] knob completely to the left to lower the volume to
the minimum level.
2
Turn down the volume control on the connected amp or audio system.
3
Press the [POWER] button to turn on the power.
1, 5 3
5
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
efore the unit will operate
normally.
If the hi-hat control pedal
(the optional FD-7; or for
the TD-6K exclusively, the
FD-6) is pressed when the
power is turned on, control
of the hi-hat’s opening and
closing will not work
correctly. Striking the pads
when turning on the
power degrades the pad
response when the pads
are struck lightly.
Precautions When Turning on the Power
After the power is turned on, the drum kit name (shown in the
following figure) appears in the display; do NOT press any pad
or pedal until [KIT] has lighted.
fig.P-002ai
To Next Page
Loading...
Need help?
General
