Roland TD-6 - Turning off the Power

25
Turning On/Off the Power
Setup Guide
4
Turn on the power to the connected amp or audio system.
5
Press [SHIFT] + [KIT] or strike the pad, and while listening to the
sound, gradually bring up [VOLUME] to adjust the volume level.
Also raise the volume level of the connected amp or audio system to the
appropriate level.
Turning Off the Power
1
Completely turn down the volume of the TD-6 and any connected
external devices.
2
Turn off the power to all external devices.
3
Press the TD-6’s [POWER] switch to turn off the power.
Caution Concerning
Volume
If the volume levels used
when striking the pads are
left unchanged when
playing back demo songs
or other songs, the volume
may increase suddenly,
which may cause ear pain
and damaged speakers.
Before playing back songs
or patterns, rotate the
[VOLUME] knob
counterclockwise to lower
the volume levels, then
readjust to a suitable
volume while listening to
the playback.
No Sound Even When Pressing [SHIFT] + [KIT]
Check the following points.
When Using an Amp or Audio System
• Is the amp or audio system volume setting correct?
• Are the TD-6 and the amp or audio system connected correctly?
• Is there a problem with any connector cable?
• Have the input select settings of your audio system or amp been
made correctly?
When using headphones:
• Are the headphones connected to the [PHONES] jack?