Roland TD-6 - Specific Part in Song Not Being Played; TD-6 Not Playing Even During Performance of External Sequencer or Keyboard; No Sound;Low volume from Device Connected to the MIX IN Jack; Drum Kit Does Not Sound As Intended

112
Troubleshooting
Specific Part in Song Not Being
Played
Does [PART MUTE] light? (p. 85)
➝ Press [PART MUTE] so that the light is turned off.
Is the volume level for each part set to “0?”
(SONG/PART/Level; p. 89)
➝ Press [INC/+] or [DEC/-] to make the setting.
TD-6 Not Playing Even During
Performance of External Sequencer
or Keyboard
Is the part’s MIDI channel correct? Or is the
channel set to “OFF?” (SETUP/MIDI PART/Part
CH; p. 102)
➝ Press [INC/+] or [DEC/-] to make the setting.
Is the volume level for each part set to “0?”
(SONG/PART/Level; p. 89)
➝ Press [INC/+] or [DEC/-] to make the setting.
External Sequencer Not Playing
Even During Performance of TD-6
and Pads
Is the part’s MIDI channel correct? Or is the
channel set to “OFF?”
(SETUP/MIDI PART/Part CH; p. 102)
➝ Press [INC/+] or [DEC/-] to make the setting.
In GM mode, No Sound of a
Specific Part in a Performance
Is it set not to receive MIDI messages?
(SETUP/GM PART/Part Rx Sw; p. 103)
➝ Press [INC/+] or [DEC/-] to make the setting.
No Sound/Low volume from
Device Connected to the MIX
IN Jack
Could you be using a connection cable that
contains a resistor?
➝ Use a connection cable that does not contain a resistor.
Is the volume level of the connected device
turned down completely?
➝ Refer to the owner’s manual for the device, then set the
volume.
Drum Kit Does Not Sound As
Intended
Pressing [SHIFT] + [KIT] (Preview)
Starts Playback of the Song
Is the Pad Pattern function (a feature that
starts performance of songs when a pad is
struck) specified for the selected pad?
(KIT/CONTROL/Pad Ptn; p. 65)
➝ Press [DEC/-] to set this to “OFF.”
To stop playback of a song in progress, press [STOP ].